
24 Hour Call Out Electricians
No Power & Tripping Fuses in Rye
No power, or a fuse board that trips every time you reset it? We find out why and get your electricity back on safely.
- Whole-house and part-house power loss
- Fuse boards that won't reset
- With you in 30 to 90 minutes
- Clear pricing before we start
Common causes
Why the power goes off
Power loss has a handful of common causes. We check each one until we find yours.
Tripped main switch or RCD
One fault can take out the whole house. We find the circuit responsible and restore the rest.
Faulty appliances
A failing kettle, oven or washing machine can trip the power every time it's used.
Overloaded circuits
Too many high-power appliances on one circuit will trip it. We check the load and advise on a fix.
Failed fuse board parts
Breakers, RCDs and main switches wear out. We replace failed parts so the board protects you again.
Water in the electrics
Rain, leaks and condensation in outdoor fittings are a frequent cause of trips.
Supply problems
Sometimes the fault is on the network, not in your home. We confirm it and tell you who to call.
The fault explained
Power loss and tripping explained
When the power goes off, either the protective devices in your fuse board have done their job, or the supply has failed. Knowing which, and why, is the key to getting you back on safely.
What's going on
Your fuse board contains several types of protection. Circuit breakers (MCBs) switch off when a circuit draws too much current or has a short circuit. RCDs switch off when current leaks to earth, which is what happens when someone gets a shock or water gets into a fitting. In older properties you may still have rewireable fuses, which melt rather than trip.
If one RCD covers several circuits, a single fault can take out half the house. If the main switch or a main RCD trips, you may lose everything. And sometimes the problem isn't in your home at all: it's a power cut on the network or a fault with the incoming supply.
The most common causes
- Earth leakageCurrent escaping to earth through damp, damaged insulation or a faulty appliance trips the RCD.
- OverloadRunning too many high-power appliances at once on one circuit trips its breaker.
- Short circuitLive and neutral touching, from a damaged cable or failed appliance, trips the breaker instantly.
- Failed protective deviceBreakers and RCDs can wear out and trip for no reason, or fail to reset.
- Several small leaks adding upA number of appliances each leaking a little current can add up to enough to trip a shared RCD.
- Supply problemsA network power cut or a fault on the incoming supply needs your network operator. Call 105 to report it.
How we fix it
First we confirm whether the supply is reaching your property. If it isn't, we'll tell you who to call. If it is, we isolate each circuit in turn to find which one is causing the trip, and restore power to all the healthy circuits so you're up and running while we work.
On the faulty circuit we test insulation resistance to find leakage, use a clamp meter to check for overload, and test the breaker or RCD itself to see whether it's tripping correctly. The repair might be replacing a damaged accessory, repairing a cable, rebalancing an overloaded circuit or replacing a failed device. Everything is tested again before the circuit goes back on.
Quick checks
Before you call
These checks are safe to do yourself and can save you a callout.
Check with a neighbour
If their power is off too, it's a power cut. Call 105 to report it.
Look at the fuse board
See which switch is down. Don't force anything that won't stay up.
Unplug and reset once
Unplug the appliances on that circuit, then try the switch once. If it trips again, leave it off.
Call us
If the power won't stay on, or you see scorching or smell burning, ring 01797 000000.
Electrical emergency right now?
We're with you in 30 to 90 minutes, day or night.
No power
Power cut, trip switch or tripping fuse box
People describe the same problem in lots of ways: no electricity, a power cut, half the house with no power, the trip switch has gone, the fuse box keeps tripping, or the RCD won't reset. All of them mean the power is off and you need to know why.
If the whole street is out, it's a network power cut and you should call 105. If it's just your property, it's usually a fault that has tripped your MCB, RCD or main switch. Our emergency electricians in Rye find which circuit is responsible and get the rest of your electricity back on while we fix it.
Whether you need a call out electrician for a tripping fuse box at night, an out of hours electrician for a total loss of power, or a same day electrician to sort a breaker that keeps tripping, we cover Rye and the surrounding villages 24/7.
Questions
Frequently asked questions
Is it safe to keep resetting a tripped switch?
No. If it trips again straight away, there's a fault. Repeated resetting can make it worse, so leave it off and call us.
Only half my house has no power. Why?
One circuit or one side of the fuse board has tripped. It still needs checking, but you can usually use the rest safely.
Is it a power cut or a fault in my house?
If the neighbours are off too, it's a power cut, so call 105. If it's only you, it's likely a fault in your own installation.
Do I need a new fuse board?
Not always. Often one part has failed and can be replaced. If the board is old or damaged, we'll explain your options.
More help




